Cold email deliverability comes down to four things: a sending setup that passes authentication, a sending pattern mailbox providers trust, a list of real people who are likely to want the email, and low complaint rates. Gmail and Yahoo have required authentication and low spam rates from senders since February 2024. Meeting those rules gets you considered for the inbox. Sending fewer, better-targeted emails is what keeps you there.
Most deliverability advice focuses on tools: warmup services, inbox rotators, spam-word checkers. Those can help at the margins. But the biggest levers are usually setup and targeting. If people mark your email as spam, no tool will fix your reputation.
What decides whether cold email reaches the inbox
Mailbox providers decide where an email goes based on signals they see, including:
- Authentication: whether the message passes SPF, DKIM and DMARC, and whether those line up with the From: domain.
- Reputation: the history of the sending domain and IP addresses, including complaints and bounces.
- Engagement and complaints: how recipients react, especially how often they mark mail as spam.
- Message and infrastructure basics: valid DNS records, encrypted connections and properly formatted messages.
You control all of these, directly or indirectly. The rest of this guide goes through each one.
What do Gmail and Yahoo require from cold email senders?
Both require SPF or DKIM, valid forward and reverse DNS and a spam rate below 0.3%, and add SPF plus DKIM, DMARC, alignment and one-click unsubscribe for bulk senders.
Google's email sender guidelines set requirements that apply to anyone sending to personal Gmail accounts, starting February 1, 2024. Here is how Google's requirements compare with Yahoo's bulk-sender rules:
| Requirement | Google, all senders | Google, 5,000+/day | Yahoo, bulk |
|---|---|---|---|
| SPF or DKIM | Required | SPF and DKIM | SPF and DKIM |
| DMARC | Not listed | Required (p=none allowed) | Required (at least p=none, passing) |
| From: alignment | Not listed | Required | Required |
| One-click unsubscribe (marketing and subscribed mail) | Not listed | Required | Required |
| Visible unsubscribe link in the message body | Not listed | Required | Required |
| Spam rate | Below 0.3% | Below 0.3% (aim below 0.10%) | Below 0.3% |
Google also requires all senders to have valid forward and reverse DNS records for sending IPs and to use a TLS connection for transmitting email. Spam rates are the ones reported in Postmaster Tools, and Google recommends keeping them below 0.10%.
Yahoo's Sender Hub best practices describe a similar set of rules, with enforcement beginning in February 2024. Yahoo says all senders need SPF or DKIM, a spam rate below 0.3%, valid forward and reverse DNS, and messages that comply with RFC 5321 and RFC 5322. For bulk senders, Yahoo adds SPF and DKIM, a DMARC policy of at least p=none that passes, From: domain alignment, one-click list-unsubscribe for marketing and subscribed mail, a visible unsubscribe link in the message body and honoring unsubscribes within two days. Yahoo's best practices page does not publish a specific daily volume that makes you a bulk sender, so plan as though the bulk rules apply to you.
Cold outbound is not marketing to subscribers, but treat these rules as the baseline anyway. Many cold sending setups add up to high daily volume across mailboxes, and the authentication and complaint rules apply to everyone.
US senders also need to follow the CAN-SPAM Act. The FTC's compliance guide says the law makes no exception for business-to-business email. Among its requirements: no false or misleading header information, no deceptive subject lines, a valid physical postal address, a clear way to opt out, and honoring opt-out requests within 10 business days.
Should you send cold email from a separate domain?
Many B2B teams send cold email from secondary domains rather than their main company domain. The reasoning is risk separation. If a cold campaign damages the reputation of a secondary domain, your main domain, which carries invoices, customer support and employee email, is not directly hit.
If you use secondary domains:
- Make them recognizably yours. A domain that looks related to your brand is less confusing for recipients than an unrelated one.
- Set up each domain fully. SPF, DKIM, DMARC, valid DNS and a real website or redirect to your main site.
- Use real mailboxes with real names. Each mailbox should be able to receive and answer replies.
- Keep the sender identity honest. The From: name and the signature should be a real person at your company.
Separation limits damage. It does not make poor sending practices safe. A secondary domain with high complaints will still end up in spam, and recipients still associate the email with your brand.
What are SPF, DKIM, DMARC and alignment?
These three records work together:
- SPF (Sender Policy Framework) lists the servers allowed to send email for your domain. Receivers check whether the sending server is on that list.
- DKIM (DomainKeys Identified Mail) adds a cryptographic signature to each message. Receivers use a public key in your DNS to confirm the message was not altered and came from your domain.
- DMARC tells receivers what to do when a message fails SPF and DKIM checks, and lets you receive reports on who is sending as your domain. Google allows a policy of none for bulk senders, which monitors without blocking.
Alignment is the part teams often miss. It means the domain in the visible From: header matches the domain that passed SPF or DKIM. If you send through a third-party tool that signs with its own domain instead of yours, your messages may pass authentication but still fail alignment. Check your sending tool's documentation for how to set up custom DKIM on your own domain.
Do you need DMARC for cold email? Under Google's rules, DMARC is required once you send more than 5,000 messages a day to Gmail accounts, and Yahoo requires it for bulk senders. Even below those levels, setting a DMARC record is a sensible default.
How many cold emails can you send per day?
There is no official per-inbox daily limit for cold email from Google or Yahoo. What the rules make clear is that complaint rates matter, and complaints rise when you send a lot of email to people who did not expect it.
What usually helps:
- Ramp new domains and mailboxes gradually. A new domain that suddenly sends a lot of mail has no history to support it.
- Spread volume across mailboxes instead of pushing one inbox hard, while keeping total volume tied to how many good prospects you actually have.
- Keep sending consistent. Sudden spikes are harder for providers to trust than steady patterns.
What doesn't help much on its own:
- Warmup tools as a fix for bad targeting. Warmup may help a new mailbox look active, but it cannot offset real recipients marking your mail as spam.
- Rotating domains to escape complaints. Burning through domains hides the problem for a while and repeats it on every new domain.
Our guide to sales outreach automation systems that scale covers how sending limits fit into a larger outreach system, so we won't repeat it here.
Message content still matters, but mostly at the margins: keep links few, avoid heavy images and tracking-heavy templates, and write plain, specific messages. Sequence length and copy get their own treatment in an upcoming post on outbound sequence structure.
List quality and targeting as deliverability levers
This is where B2B teams have the most control and use it least.
- Verify addresses before sending. Bounces hurt sender reputation. Validate emails, and handle catch-all addresses carefully.
- Remove role and stale addresses. Generic inboxes and people who left the company add risk with no upside.
- Send to people with a reason to hear from you. Signal-based outbound targets accounts showing real buying signals, such as hiring, funding or technology changes. Fewer, more relevant emails mean fewer spam complaints.
- Honor opt-outs quickly and keep a suppression list that every sending tool uses.
Our explainer on signal-based outbound covers how to find those accounts, and our comparison of signal-based outbound vs. traditional lead gen explains why fewer, better emails tend to outperform bulk sends. For the wider strategy, see our guide to B2B outbound marketing. Keeping contact data clean in the CRM also matters, which our upcoming post on HubSpot data hygiene covers.
Email is also not the only channel. Our upcoming post on signal-based LinkedIn outreach covers reaching the same accounts without adding more email volume.
How do you monitor deliverability?
You cannot manage what you do not measure. Set up:
- Google Postmaster Tools for each sending domain. Google's spam-rate requirement is based on the rate reported there, so this is the number that matters for Gmail.
- DMARC reports to see who is sending as your domain and whether messages pass.
- Bounce tracking by domain, mailbox and list source. A spike in bounces often points to a bad list or enrichment source.
- Reply and unsubscribe monitoring. Rising unsubscribes or angry replies are an early warning before spam complaints show up.
When numbers move the wrong way, slow down first. Pause the affected mailbox or campaign, find the cause and fix it before adding volume back.
Building outbound that stays in the inbox
Deliverability is not a setting you turn on. It is the result of authentication, careful volume, good lists and relevant messages working together. If you want help building an outbound system around those principles, our B2B pipeline generation service covers targeting, sending setup and sequencing.
Frequently Asked Questions
Is cold email deliverability just domain reputation?
No. Reputation matters, but mailbox providers also look at authentication, alignment, DNS and TLS, complaint rates and how recipients engage. A good reputation can be damaged quickly by a poorly targeted campaign.
Do I need separate sending domains for cold email?
Many B2B teams use secondary domains to separate cold outreach risk from their main domain. It limits damage but does not make poor practices safe. Each domain needs full authentication and an honest sender identity.
How many cold emails can I send per inbox per day?
Google and Yahoo do not publish a per-inbox limit for cold email. Ramp new mailboxes gradually, keep volume steady and tie total volume to the number of good prospects you have. Watch spam rates and bounces, and slow down when they rise.
Do I need DMARC for cold email?
Google requires DMARC for senders of more than 5,000 messages a day to Gmail accounts, and Yahoo requires it for bulk senders. A policy of p=none is accepted. Setting up DMARC is a sensible default at any volume.
What spam rate do Gmail and Yahoo allow?
Both say senders must keep spam rates below 0.3%. Google recommends staying below 0.10%, measured in Postmaster Tools.
